UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 62160

MIG 7 series - Is Dynamic ODT supported?

描述

Version Found: MIG 7 Series v2.1
Version Resolved: See (Xilinx Answer 54025)
 
Does MIG 7 series support Dynamic ODT?

It is mentioned in UG586.

UG586 June 4, 2014 Table 1-92:  RTT_WR:

This is the dynamic ODT write termination used in multiple-RANK designs. For single-component designs, RTT_WR should be disabled.

解决方案

MIG 7 series does not support Dynamic ODT.
 
The parameter should always be set to "OFF".
 
(Xilinx Answer 46082) describes a solution for Dynamic ODT support but it is only for "special use of Dynamic ODT supported by Micron". 

Revision History
09/24/2014 - Initial Release
 
Note: The "Version Found" column lists the version the problem was first discovered.
The problem also exists in earlier versions, but no specific testing has been performed to verify earlier versions.

链接问答记录

主要问答记录

Answer Number 问答标题 问题版本 已解决问题的版本
54025 MIG 7 Series - IP Release Notes and Known Issues for Vivado N/A N/A
AR# 62160
日期 10/08/2014
状态 Active
Type 已知问题
IP
的页面