We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 65947

LogiCORE Tri Mode Ethernet MAC v9.0 (Rev 3) - UltraScale Plus Devices - GMII/RGMII - Timing not met on I/O Interface


When using the Tri-mode Ethernet MAC core (v9.0 rev 3) in Vivado 2015.4 to target an UltraScale Plus device with a GMII/RGMII interface, the constraints on the I/O paths are not completely met and you might see Setup/Hold violations on these paths.

This is similar to what has been seen for UltraScale devices in previous releases. (See (Xilinx Answer 60198))


To get timing closure for these I/O constraints, you will need to LOC down the package pins and the clocking elements to be in the same clock-region.

Attached to this Answer Record are LOC constraints examples for a few Kintex and Zynq US+ devices, for both GMII and RGMII mode.


文件名 文件大小 File Type
gmii_locs.txt 8 KB TXT
rgmii_locs.txt 5 KB TXT
AR# 65947
日期 11/24/2015
状态 Active
Type 综合文章
  • Kintex UltraScale+
  • Virtex UltraScale+
  • Vivado Design Suite - 2015.4
  • Tri-Mode Ethernet MAC