AR# 67006

7 Series Integrated Block for PCI Express (Vivado 2013.4) - Incorrect completion behaviour with the example design when s_axis_tx_tready is deasserted

描述

When using the 7 Series Integrated Block for PCI Express core example design in Vivado 2013.4, incorrect behavior is seen with completion being sent out when s_axis_tx_tready is not continuously asserted.


This article is part of the PCI Express Solution Centre

(Xilinx Answer 34536) Xilinx Solution Center for PCI Express

解决方案

This is a known issue with the example design logic. This has been fixed in Vivado 2014.2. 

To work around this issue, replace the following code:

reg s_axis_tx_tready_i;

always @(posedge user_clk)

begin

     if (user_reset)

          s_axis_tx_tready_i <= #TCQ 1'b0;

    else

        s_axis_tx_tready_i <= #TCQ s_axis_tx_tready;

    end

Replace it with this code:

wire s_axis_tx_tready_i;

assign s_axis_tx_tready_i = s_axis_tx_tready

AR# 67006
日期 04/18/2016
状态 Active
Type 综合文章
IP