AR# 8725

Virtex/-E - What is the strength of the internal pull-up or pull-down resistors in the Virtex/-E I/O blocks?

描述

What is the strength of the internal pull-up or pull-down resistors in the Virtex/-E I/O blocks?

解决方案


The maximum strength (lowest resistance) is defined by Irpu and Irpd in the DC and Switching Characteristic Data Sheet.  
 
The Virtex Data Sheet can be found at: 
http://www.support.xilinx.com/xlnx/xweb/xil_publications_display.jsp?sGlobalNavPick=&sSecondaryNavPick=&category=-18777&iLanguageID=1
 
The Virtex-E Data Sheet can be found at: 
http://www.support.xilinx.com/xlnx/xweb/xil_publications_display.jsp?sGlobalNavPick=&sSecondaryNavPick=&category=-18776&iLanguageID=1
 
The pull-up resistor will range from 13.2K to 100K Ohms. The strength of the pull-up will decrease as VCCO decreases (resistor value increases). The strength of the pull-down will have the opposite affect when VCCO decreases. As VCCO decreases, the strength of the pull-down increases (resistor value decreases). In either case, the pull-up or pull-down resistor range is sufficient to either hold a logic level High or logic level Low.
AR# 8725
日期 07/02/2014
状态 Archive
Type 综合文章