I use IP MIPI-CSI2 Receiver Subsystem v5.1 with 1.5G and 2G data rate. When I config data rate with 2G and whatever I enable or disable skew funct...

PS_error and INIT LEDs RED on power on ZCU1275 RFSoC

A gift to the forums: Asynchronous Clock Domain Crossing technique

Can anyone recommend a 32GB Sodimm for use on a zcu106 development board? The zynq ultrascale+ TRM lists memory capacity up to 34G, but has anyone ...

How do we recover after a VDMA lockup for early/late SOF

If I read " REGISTER.CONFIG_STATUS.BIT12_INIT_B_PIN string true 1 " and yet measure that it is 0 Volts on the physical pin does this mean the conf...

Do the Ultrascale+ family of SOCs support DDR4 ECC with 16 and 32-bit data interfaces through the programmable logic (PL)? Specifically would like...

ZYNQ UltraScale+ MPSoC Boot from SD Card - Not default MIO pins

How can I use a License Voucher never used but expired?

Is it normal for the VCK190's fan is spinning at high speed very often with no load?

Why AXI VIP Simulation stops at Line 1087 of file 'axi_vip_if'?

SP701, Pcam 5C module video transmsssion

Trouble getting SDT based yocto build with 2024.2 toolset

Missing IP : Clocking Wizard

retrieving parts ZCU670