We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 14196

Virtex-II, DCI/XCITE - What happens if the VRN or VRP pins are left unconnected?


What happens if the VRN or VRP pins are left unconnected?


When the VRN/VRP pins are left unconnected, the DCI will attempt to match the "infinite impedance".

- For LVDCI and LVDCI_DV2 standards, the output will effectively be 3-stated.

- For most HSTL_DCI, SSTL_DCI, and GTL_DCI standards, the on-chip terminations will be turned completely off. (The exceptions are HSTL_IV_DCI, GTL_DCI, and GTLP_DCI, for which a small part of the termination is turned on as part of the bit stream; therefore, that portion will remain on even when the VRN and VRP pins are disconnected.)

Leaving VRN/VRP disconnected will not damage the device. It will dissipate more power than, for example, a case where the DCI were not turned on, as the DCI control logic would still be active.

Disconnecting the VRN/VRP pins after configuration will increase the impedance of on-chip terminations, but it will not turn the DCI off completely.

NOTE: Some DCI outputs do not require a reference resistor, so they are not affected if the VRN/VRP pins are left unconnected.

Please see (Xilinx Answer 14128) for more information.

AR# 14196
日期 12/15/2012
状态 Active
Type 综合文章