We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 42783

MIG DDR2/DDR3 - Termination for Data Mask (DM) Signal when DM is disabled


The Memory Controller drives the Data Mask (DM) signal when it is enabled during MIG generation through the CORE Generator tool.

However, if the DM signal is disabled, all DM signals should be pulled to ground at the memory with a resistor value set defined by the memory vendor. 

Make sure that you verify all terminations through IBIS or other signal integrity simulations.

NOTE: This answer record is a part of the Xilinx MIG Solution Center (Xilinx Answer 34243)

The Xilinx MIG Solution Center is available to address all questions related to MIG.

Whether you are starting a new design with MIG or troubleshooting a problem, use the MIG Solution Center to guide you to the right information.


It is necessary to pull down the Data Mask signal at the memory.

The FPGA is no longer driving the DM when DM is disabled, and therefore it must be properly pulled down to prevent accidental masking of data during writes to the memory. 

If the DM is not terminated properly, it can cause calibration failures and data errors during normal operation. 

Refer to the memory vendor datasheet for appropriate termination. 

Inappropriate termination can cause problems.



Answer Number 问答标题 问题版本 已解决问题的版本
34556 MIG Virtex-6 DDR2/DDR3 - Termination and I/O Standard Guidelines N/A N/A
AR# 42783
日期 08/28/2014
状态 Active
Type 解决方案中心
器件 More Less