You are using a deprecated Browser. Internet Explorer is no longer supported by Xilinx.
MIG 7 Series DDR3 - A few DDR3 SDRAM parts support both 1.5V and 1.35V
Version Found: v1.6
Version Resolved and other Known Issues: See (Xilinx Answer 45195)
The following list of DDR3 SDRAM parts support both 1.5V and 1.35V standards, however MIG 7 series supports them as 1.35V parts only:
MIG 7 Series should support parts on this list as both 1.5V and 1.35V parts.
You can target them as 1.5V parts by creating a custom memory part in the MIG GUI.
When creating a custom memory part, choose a 1.5V part as your "base part," and then manually enter the timing specifications for your memory part.
These can be taken from the memory vendor's data sheet.