UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 50875

Zynq-7000 SoC ZC702 Evaluation Kit - Why does my board not have the SW16 switch as shown in the User Guide?

描述

UG926, Zynq-7000 All Programmable SoC ZC702 Evaluation Kit Getting Started Guide, lists SW16 as the five-position DIP switch used to set the configuration mode.

My ZC702 does not show this SW16 - why is that?

解决方案

SW16 (light blue / grey 5-position DIP switch) is present on Rev D and later revisions of ZC702, as shown below:

 

50875-1.jpg



Earlier revisions of the ZC702 Evaluation Kit, such as Rev B or Rev C, do not have this DIP switch present. 

 

Instead, the mode is set using the jumpers immediately below the FMC headers as shown below:

 

50875-2.jpg

 

 

These are jumpers J20, J21, J22, J25 and J26.

The jumpers correspond to the settings in SW16 as follows:

 

50875-3.jpg

 

链接问答记录

主要问答记录

Answer Number 问答标题 问题版本 已解决问题的版本
47864 Zynq-7000 AP SoC ZC702 Evaluation Kit - Known Issues and Release Notes Master Answer Record N/A N/A
AR# 50875
日期 11/13/2017
状态 Active
Type 综合文章
Boards & Kits
  • Zynq-7000 SoC ZC702 Evaluation Kit
的页面