2. 技术支持
  3. AR# 52791: v14.3 - EDK : AXI Datamover v3.00.a AXI reset ports not connected automatically. Results in WARNING:EDK:4180

AR# 52791

|

v14.3 - EDK : AXI Datamover v3.00.a AXI reset ports not connected automatically. Results in WARNING:EDK:4180

描述

When the AXI Datamover is added with no changes, the following warnings (Not Errors) are seen:
 

WARNING:EDK:4180 - PORT: m_axi_mm2s_aresetn, CONNECTOR:
   axi_interconnect_1_S_m_axi_mm2s_aresetn - No driver found. Port will be
   driven to GND -
   C:\Xilinx\14.2\ISE_DS\EDK\hw\XilinxProcessorIPLib\pcores\axi_datamover_v3_00_
   a\data\axi_datamover_v2_1_0.mpd line 130


  

WARNING:EDK:4180 - PORT: m_axi_s2mm_aresetn, CONNECTOR:
   axi_interconnect_1_S_m_axi_s2mm_aresetn - No driver found. Port will be
   driven to GND -
   C:\Xilinx\14.2\ISE_DS\EDK\hw\XilinxProcessorIPLib\pcores\axi_datamover_v3_00_
   a\data\axi_datamover_v2_1_0.mpd line 131

解决方案

The reset signals are supposed to be connected.

If they are not connected, they should be connected to Vcc.

To resolve this Tie to Vcc in SAV.

This has been fixed and verified for the AXI Datamover v4.02a.
AR# 52791
日期 09/05/2014
状态 Active
Type 综合文章
器件
Tools
IP
People Also Viewed