AR# 57437

MIG 7 Series QDRII+ - SIM_BYPASS_INIT_CAL="SKIP" is not supported for simulations

描述

Version Found: v2.0
Version Resolved: See (Xilinx Answer 54025)

Simulation parameter SIM_BYPASS_INIT="SKIP" is not supported for QDRII+ interface types. Calibration might never complete if SKIP is used.

解决方案

The 7 Series FPGAs Memory Interface Solutions v2.0 User Guide (UG586) suggests that SKIP is a supported value for the SIM_BYPASS_INIT parameter, but this is incorrect.

The following are the only supported values for the SIM_BYPASS_INIT parameter:

"FAST"
"OFF"

Revision History
09/12/2013 - Initial release

AR# 57437
日期 09/26/2013
状态 Active
Type 已知问题
器件
IP