UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

AR# 61576

MIG 7 Series DDR3 - After re-customizing, ECC will become "Disabled" even though it was originally "Enabled"

描述

Version Found: MIG 7 Series v2.1
Version Resolved: See (Xilinx Answer 54025)


In some cases if ECC is "Enabled" for a MIG DDR3 AXI 72-bit design and then re-customized the MIG GUI will show that ECC is "Disabled".
 
MIG_ECC.png

解决方案

This is an issue with the MIG GUI only, the correct configuration will be generated if you manually change the ECC setting back to "Enabled".

Revision History

07/29/2014 - Initial Release

链接问答记录

主要问答记录

Answer Number 问答标题 问题版本 已解决问题的版本
54025 MIG 7 Series - IP Release Notes and Known Issues for Vivado N/A N/A
AR# 61576
日期 07/30/2014
状态 Active
Type 已知问题
Tools
IP
的页面