AR# 61612

LogiCORE IP SMPTE SD/HD/3G-SDI (SMPTE SDI) v3.0 - When using XAPP592 v2.0, why does the SMPTE 352 payload ID capture module in the SMPTE SDI receiver core lock up when the GTX RX changes line rates?

描述

When using XAPP592 v2.0, why does the SMPTE 352 payload ID capture module in the SMPTE SDI receiver core lock up when the GTX RX changes line rates?

解决方案

In XAPP592 v2.0, the SMPTE ST 352 payload ID capture module in the SMPTE SD/HD/3G-SDI cores receiver can become stuck in an illegal state when the GTX RX changes line rates. 
 
To prevent this, it is recommended that RX portion of the SMPTE SD/HD/3G-SDI core be reset using the rx_rst port after any SDI mode change. 
 
One simple way to do this is to assert the rx_rst port High whenever the rx_change_done output of the x7gtx_sdi_control module is Low. 
 
Note:

The x7gtx_sdi_control module is supplied with XAPP592. 
 
The rx_change_done output must be synchronized to the rx_usrclk domain before it can be used to control rx_rst.

This issue has been fixed in the XAPP592 v2.1.

链接问答记录

主要问答记录

Answer Number 问答标题 问题版本 已解决问题的版本
54531 LogiCORE IP SMPTE SD/HD/3G-SDI (SMPTE SDI) - Release Notes and Known Issues for Vivado 2013.1 and newer tool versions N/A N/A
AR# 61612
日期 08/05/2014
状态 Active
Type 综合文章
IP