AR# 71028

2018.1-2018.3 Zynq UltraScale+ MPSoC: PetaLinux Warm-Restart BSP fails to wake up Ethernet

描述

In 2018.1-2018.3 PetaLinux, warm-restart BSP fails to wake up Ethernet. 

Wakeup on LAN (WOL) requires an RX BD scratch area that is accessible to the DMA, and it should be set up with a tie off descriptor.

OCM is used for this purpose, but it is not possible in the isolation design because OCM is secure.

As a result, wakeup on LAN does not work with the below design configurations because non-secure GEM cannot access secure OCM:


  1. Isolation is enabled.
  2. OCM is TZ secure and OCM_XMPU protection is enabled.
  3. GEM is TZ non-secure.

解决方案

The following are possible work-arounds:

  1. Disable OCM_XMPU protection (make OCM non-secure).
  2. Make GEM TZ secure with the below configurations using Vivado design suite:
    • Add a Secure GEM master in the APU secure subsystem.
    • Add a GEM peripheral (non-secure) and OCM (secure) in the PMU Subsystem
  3. Make GEM TZ secure and add a GEM master in the OCM XMPU region during suspend when Ethernet is set as the wakeup source in the PMUFW (See the Attached patch 0001-pmufw-Changes-for-wakeup-on-LAN-for-isolation-design.patch)


Steps to make WOL work using 0001-pmufw-Changes-for-wakeup-on-LAN-for-isolation-design.patch:

a) Create an isolation design with the below configuration:

  1. Enable isolation
  2. Add OCM TZ secure to the APU Secure subsystem
  3. Add GEM peripheral (secure/non-secure) and OCM (Size: 256KB) TZ secure to the PMU subsystem
  4. Generate HDF with the above configurations

b) Copy the attached patch to the pmu-firmware directory. 

If this directory does not exist, create one in the meta-user layer:

$ cp 0001-pmufw-Changes-for-wakeup-on-LAN-for-isolation-design.patch <plnx-proj-root>/project-spec/meta-user/recipes-bsp/pmu-firmware/files


c) Add the patch to the pmu-firmware_%.bbappend recipe and build the images.


SRC_URI_append = " \
        file://0001-pmufw-Changes-for-wakeup-on-LAN-for-isolation-design.patch \
        "
 
FILESEXTRAPATHS_prepend := "${THISDIR}/files:"

# Note: for 2018.3 release onwards you don't belwo variables.

EXTERNALXSCTSRC = ""
EXTERNALXSCTSRC_BUILD = ""

d) Use the PMUFW and FSBL generated in step c to boot Linux

e) Perform the steps described on the Wake on LAN page.

Note:

  • Changing the XMPU/XPPU configurations runtime can cause improper behavior if any other subsystem is running while suspending one subsystem with Ethernet as the wakeup source.
  • 0001-pmufw-Changes-for-wakeup-on-LAN-for-isolation-design.patch does not take care of ongoing transactions and it is tested and verified only while the APU subsystem is running.
  • 0001-pmufw-Changes-for-wakeup-on-LAN-for-isolation-design.patch is not part of the embeddedsw git repo.

附件

文件名 文件大小 File Type
AR71028-patch.zip 3 KB ZIP
AR# 71028
日期 12/10/2018
状态 Active
Type 综合文章
器件
Tools More Less
Boards & Kits